### How To Open A Combination Safe With 5 Numbers References

How To Open A Combination Safe With 5 Numbers References. For additional instructions, check the manual of your safe. If there is no safe handle, then turning the dial back to the right again will unlock the safe.

1) spin the dial left (ccw) at least four times and stop on the first number of the combination. Turn the keypad clockwise until it stops within six seconds and open your safe. You then enter your new combination and press a or the pound key, depending on your safe.

### To Open Combination Locks Without A Code, Start By Pulling Up On The Dial And Turning It Clockwise Until You Hear The Lock Click.

From emory university and is a member of the utah state bar. Reply to jeffrey flaker's post: How to open a combination safe with 5 numbers.

### Avoid Spinning The Dial Too Far, Or Else You’ll Cause The Safe To Lock Again.

Finish turning the dial when you reach the final combination number. Once open, locate a red button on the door and press it. Adjacent combination numbers should not be closer than five numbers to each other.

### A Very Small Number Start To The Right, Then Left, Then Right.

Insert change key into back of lock. Then, slowly turn the dial clockwise until it stops. Keep rotating the dial to the left and slow down as you get closer to the last number.

### This Set Of Numbers Is Merely A Way Of Wiping The Slate Clean For You To Set A New Code To Your Safe.

If using the serial number method, simply dial an incorrect combination to get a lightning bolt. 4) spin the dial right until the dial stops by itself. Then, write down whatever number you're at.

### Turn The Keypad Clockwise Until It Stops Within Six Seconds And Open Your Safe.

Then, slowly turn the dial clockwise until it stops. Then, check what number you're at, add 5 to that number, and write it down. 3) spin the dial left (ccw) and stop on the third number the 2nd time the number comes under the opening mark.