How To Light A Pilot Light On A Rheem Water Heater References. Push down the red button to the left of the gas knob. When the flame ignites, continue to hold the gas knob or button down for a full minute.
This same instruction set should be available as a sticker on your unit. Make sure to follow the lighting instructions carefully and do not skip any steps. Rotate the gas knob of your rheem water heater clockwise until it reaches the “off” position.
Table of Contents
It Will Light And Stay Lit For Awhile And Then Go Out.
If you’re going on extended vacations, you should turn off the pilot light. It looks like you do in fact have to depress the knob in order to turn it so avoid using force. You may have to press the ignitor button a couple times until the pilot is lit.
This Will Allow The Main Burner.
When the flame ignites, continue to hold the gas knob or button down for a full minute. To turn on the pilot, continue pressing the red button until the piezo igniter strikers appear close to the gas knob. Press down on the ignitor button while holding the red set button, until you see the pilot light come on.
Rheem Water Heater Instruction Manuals.
Make sure to follow the lighting instructions carefully and do not skip any steps. A rheem water heater pilot light needs to be lit manually using the piezo ignitor striker built into the water heater. For instructions specific to your brand of water heater, scroll below.
Rotate The Gas Knob Of Your Rheem Water Heater Clockwise Until It Reaches The “Off” Position.
Push Down The Red Button To The Left Of The Gas Knob.
Rotate the temperature dial of the water heater counterclockwise, until it reaches the lowest setting. Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. Hold the red button down while you do so.