How To Light A Furnace With Electronic Ignition References

How To Light A Furnace With Electronic Ignition References. Because an electric ignition does not need constant power the way a pilot light does, it contributes to energy savings. The pilot flame should light immediately.

Electronic Ignition in a Furnace Why It's Better Than a from www.purlsheetmetal.com

Newer furnaces light with electronic ignition rather than a pilot light. If your furnace is equipped with an electronic igniter, you cannot light the furnace manually. Press the gas control knob down all the way and hold it in the depressed position.

If You Can’t Find The Ignition Button, Check The Instruction Sticker On Your Furnace Or The The Owner’s Manual.

The pilot light has a small gas line running to it. The electric ignition is one of the reasons modern furnaces have seen a rise in afue ratings (annual fuel utilization efficiency) and have remained competitive with other, newer. However, you may be able to get the furnace working by turning off the igniter and resetting it.

The First Is Called An Electric Spark Igniter, Which Activates The Pilot Light Only At Times When It’s Needed.

When the pilot is off, you relight it by setting the dial to pilot and pushing in the control knob. Whenever you do not have an igniter, fire the match or barbecue lighter flame through the pilot tube’s end and ignite instantly. Subsequently, question is, how do you light a self furnace?

The Furnace Ignition Control Module Is An Essential Part Of Your Furnace.

Then, keep your thumb on the gas control knob, until it gets depressed. Find the paperwork for your particular furnace to locate the reset button or switch. The electronic ignition is only turned on when the furnace is ready to begin a heating cycle, and it eliminates the need for a constant fuel supply that a conventional pilot light requires.

But The Next Time The Furnace Kicks In, The Igniter Will Light The Gas For A Few Seconds Then It Quits.

This should light the furnace pilot light.to locate the pilot light on a gas furnace, you first have to remove the access cover, which usually just lifts off.turn the gas control to pilot and hold it in while you light the flame with a match or a lighter.turned back on electricity to unit, but still no ignition. Listen for the sound of the spark or watch for the hot surface ignitor to glow. Meanwhile, intermittent systems use an electric spark that automatically turns on the pilot.

If You Want To Find Your Ignitor, Look In The Same Place Where You’d Normally Look For A Pilot Light.

It may be necessary to light the furnace by following any manufacturer’s instructions when it has a pilot light. Relight the pilot light with the ignition button, if your furnace has one. If you have a spark igniter, press the.

Leave a Reply

Your email address will not be published.